After Later Audio Outs 34hp reverb and delay effects

reverb and delay effects

It’s designed to be used either on the desktop – by hand – or on the floor – by foot

In Hat mode it adds a High Pass circuit which removes the mid/bottom frequencies (characteristic of the snare strike) creating a higher spectrum output which is closer to a Hat timbre

using wavelets

Farbshaper is based on a classic circuit that turns a ramp into a sine

After Later Audio Outs 34hp reverb and delay effectsThis is for one 2hp module that can be configured in four different ways. It's a bit complicated to get your head around, but there are no electronics on this. It's just a means to connect various buses to jacks. 1) Bus outputs In this mode you get all stereo outputs for all four buses. This mode is best for using as an extra set of outputs for Bartender or for connecting to a chain of Barbacks (no need for a Bartender). It's also a way to get 3. 5mm